Cleaning And Maintenance - Gymrex GR-SPB335 Manual De Instrucciones

The user is liable for any damage resulting from
nonintended use of the device.
2.1. PRODUCT DESCRIPTION/PREPARING FOR USE
2
6
3
1
4
5
1. iSUP board
2. pump
3. paddle
4. repair kit
5. ballast
6. bag
2.1.1. PUMPING AND INSTALLATION OF BALLAST
A 2
B
1
C D
10~14PSI
E F
A. Unfold the board
B. Connect the pump
C. Inflate without exceeding the maximum allowable
pressure (10-14 PSI)
D. Slide the ballast into the assembly place
E. Secure the ballast with a clip
F. The board is ready for use
Do not use the board in shallow water due to the risk of
damage to the ballast. Do not step on the board with the
mounted ballast while the board is on the ground.
2.1.2. DEFLATING THE BOARD AND DEINSTALLATION OF
THE BALLAST
A B
C D
2
1
1
2
E
F
A. Unlock the ballast by pulling out the clip
B. Take out the ballast
C. Pump out the air
D. Press to let out air
E. Fold the board
F. The board is prepared for storage/transport
2.1.3. VALVE
The plastic tip in the valve serves to evacuate the air if it is
in the lower position. The upper position of the tip is used
to inflate the air as well as to prevent air loss.
1. If the valve is leaking or if it is impossible to inflate
the board, check the position of the plastic tip – keep
it in the upper position.
Pumping out – lower position of the tip:
1
1. plastic tip
Pumping the air – upper position of the tip
1
1. plastic tip
2. The valve may sometimes become loose, tighten it
with a wrench.
2
1
8 9
3. If the valve is damaged, it must be removed and
replaced using a wrench.

2.3 CLEANING AND MAINTENANCE

• Clean the product after every use.
• Use a soft, damp cloth and clean water for cleaning.
• The product must be stored in a cool and dry place,
protected from moisture and direct sunlight.
• After each cleaning, wipe the product with a dry
cloth.
2
1