Switching On; Operation; Changing Channels; Subtitle - Emtec S885 Manual Del Usuario

2 Switching on

Steps:
a) Turn on your TV set and select the SCART input.
b) Turn on the main power supply to the receiver and connect IR receiver to SCART receiver.

3 Operation

Changing Channels

There are four ways of channel selection - stepping through the channel list, selection by num-
ber, from the on-screen channel list, and using the electronic program guide (EPG)
Stepping through the channel list:
•
To move through the channel list, press the CH+ or CH- key on the remote
controller.
Selection by number:
•
Enter the channel list number directly by remote controller to select desired
channel.
•
Auto scan will clean the channels that stored first.
•
Manual scan don't clean the channels, but it will not add the repeated channels
that have stored.
Selection by on-screen channels list:
•
You can also select the required channel directly from on-screen channel list. This
is displayed using the SCART receiver 's main menu. Please press "EXIT" to go out of
channel list.
•
Select Channel menu to go submenu, press UP/DOWN cursor button preview chan-
nels and press OK button to switch to the desired channel.
Selection by EPG:
You can also select the required channel directly from electronic program guide (EPG). Like
the channel list, the EPG screen displays a list of the stored channels along with information on
what programmes are being broadcast. Steps:
•
Press the EPG button to enter the EPG menu.
•
Press the UP/DOWN cursor button to highlight channel.
•
Press OK cursor button to check program information within 30 minutes.
•
Press Exit button to switch to the desired channel and preview channel.

Subtitle

•
Press Subtitle button to switch subtitle On/Off.

Teletext

•
Press TTX button to Open/Close teletext

Volume Control

The volume level of the SCART receiver can be altered with the LEFT/ RIGHT cursor button to
remote controller.
NOTE :
The volume level selected will remain set, even when the receiver is turned off and on again,
until it's altered. You can silence the sound from the receiver by pressing MUTE button on the
remote controller.

Audio Control

You can press the LANG button to select different audio modes among STEREO, LEFT, and
RIGHT MONO
4/UK