Care Instructions - Lumos Matrix Manual Del Usuario

3) Adjust the strap tension at the buckle so that the helmet is strapped snugly.
Tighten the strap as required to obtain a snug fit. With the helmet on and
tightly fastened, make sure the helmet cannot be removed from your head or
rolled backward or forward excessively. Be sure that the buckle is not against
the jawbone.
4) When properly fitted and adjusted, your ears should not be covered by any
part of the straps.
5) Make sure you can see clearly and your peripheral vision is not blocked.
To check for proper tension, put on the helmet and fasten the buckle. Open
your mouth. You should feel the strap pulling against your chin. Then attempt
to pull the helmet off the front or rear. If the helmet comes off, increase strap
tension and examine if thick enough pads are being used. The helmet should
not be able to roll forward or backward excessively. It should not be possible
to remove the helmet without unfastening the buckle.
NOTE: Please check adjustment every time this helmet is worn.

CARE INSTRUCTIONS

1) For cleaning, only use a soft cloth, mild soap, and water to wipe down the helmet.
Please do NOT shower with your helmet. Your fit pads are removable and should be
washed by hand with mild soap and water, rinsed and then air dried only. The protec-
tion given by this helmet may be severely reduced by the application of paint, adhesive
stickers and transfers, cleaning fluids, chemicals, petroleum and petroleum products, and
other solvents. The helmet will be damaged if exposed to temperatures exceeding 62˚C
(150˚F). Never remove or modify the original elements that constitute the helmet, or add
accessories not recommended by the manufacturer, as it may risk cancelling the protec-
tive role of the helmet. During transportation, do not expose your helmet to impact or
external force. Store in a dry place, away from heat from, for example, a radiator or direct
sunlight through a car window.
2) Replacement: This helmet is designed to absorb shock through partial destruction of
the energy absorbing liner. This damage may or may not be visible to the user. After a
severe impact or blow, deep scratches or other abuse, this helmet should be destroyed
and replaced even if it appears undamaged. A helmet should also be replaced after a few
years of careful use and if it does not fit anymore.
AUSTRALIA STANDARD
(a) No Helmet can protect the wearer against all possible impacts.
(b) The helmet is designed to be retained by a strap under the lower jaw.
(c) To be effective, a helmet must fit and be worn correctly. To check for cor-
rect fit, place helmet on head and make any adjustments indicated. Securely
fasten retention system. Grasp the helmet and try to rotate it to the front
and rear. A correctly fitted helmet should be comfortable and should not
move forward to obscure vision or rearward to expose the forehead.
(d) No attachments should be made to the helmet excepte those recom-
mended by the helmet manufacturer.
(e) The helmet is designed to absorb shock by partial destrautionof the
shell and liner. This damage may not be visible. Therefore, if subjected to a
severe blow, the helmet should be destroyed and replaced even if it appears
undamaged.
(f) The helmet may be damaged and rendered in effectively by
petroleum and petroleum products, cleaning agents, paints, adhesives and
the like, without the damage being visible to the user.
(g) A helmet has a limited lifespan in use and should be replaced when it
shows obvious signs of wear.
(h) This helmet should not be used by children while climbing or
doing other activities where there is a risk of hanging or strangulation if the
child gets trapped whilst wearing the helmet.