Device Description - Leister MONO SYSTEM Instrucciones De Funcionamiento

Ocultar thumbs Ver también para MONO SYSTEM:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 37

Device description

11
10
5
6
8
Preparation
• Remove MONO from the packaging.
• Open the connection housing cover (2) by loosening the screws (3).
• Loosening the cable gland for mains connection (5).
• As required loosen the cable gland for interface (6).
Installation
• The device may only be installed by trained personnel.
• The installation must ensure that
– only cold air is supplied.
• If the air contains dust, use a Leister stainless steel filter on the blower air intake. In the case of particularly
hazardous dusts, special filters must be used to avoid short-circuits in the device.
• Protect the MONO from mechanical vibrations and shocks.
• Fasten the device on the mounting points (1) using four screws Ø M4.
• For installation dimensions, see page 3 (Size).
Connection
• The MONO must be connected by qualified personnel.
• A suitable device for complete disconnection from the mains must be provided in the mains connection!
• The device must be connected in accordance with the connection diagram and the terminal arrangement on
page 4, (Wiring Diagram) of the operating instructions:
– Carry out wiring in the connection housing (9).
• Tighten the screws for connection housing (5) and cable gland for interface (6).
• Mount connection housing cover (2) with the screws (3).
• Mount air hose to outlet opening (4) using a hose clip. Use as short as possible hoses to prevent loss of air
volume
• Connect MONO to the electrical mains.
• Switch on mains.
4
3 (4 ×)
2
9
1 (4 ×)
1 Mounting points
2 Connection housing cover
3 Screws for connection housing
4 Outlet opening / hose connection ø 38 mm
5 Cable gland for mains connection
6 Cable gland for interface
7 Air inlet flange with inner thread G 1"
8 Connector ø 38 for air hose or stainless steel filter
9 Housing cover
10 e-Drive for air setting
11 Display
17
Tabla de contenido
loading

Tabla de contenido