Lancom Systems 8011 VPN Guía De Instalación Rápida página 19

LANCOM Routers, WLAN Routers, Access Points and WLAN Controllers
Network with DHCP server
If a DHCP server is active in the LAN to assign IP addresses, an unconfigured
LANCOM device will turn off its own DHCP server. It will change into DHCP
client mode and will obtain an IP address from the DHCP server of the LAN.
This IP address is not known at first. The accessibility of the device depends
on the name resolution:
If there is a DNS server for name resolution in the LAN, which interchan-
ges the assignment of IP addresses to names with the DHCP server, then
the device can be accessed by the name "LANCOM <MAC address>" (e.g.
"LANCOM-00a057xxxxxx").
The MAC address can be found on a label at the bottom of the device.

If there is no DNS server in the LAN, or it is not linked to the DHCP server,
then the device can not be reached by the name. The following options
remain in this case:
Figure out the DHCP-assigned IP address of the LANCOM by suitable
tools and contact the device directly with this IP address.
Use LANconfig.
Connect a PC with a terminal program via the serial configuration
interface to the device.
... via serial interface
If no LAN access can be established to the device,
serial configuration interface
LANconfig or a
For outband configuration via terminal program it is not possible to

use setup wizards. The use of LANconfig is again the most convenient
configuration method.
and carry out the configuration via
terminal program.
First steps
connect the PC via the
6