Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ELECTRIC PRESSURE COOKER
·
Periodically clean the cooker and remove oil and dirt if it is stored on the table.
· Put the electric pressure cooker 30cm away from other kitchen appliances.
1.
Clean after each use.
2.
Before cleaning and maintenance, please unplug the power cord until the pro-
duct cools.
3.
Remove the lid and inner pot, clean with detergent first, then rinse well with
water, and wipe dry with a soft cloth.
4.
Clean the internal side of the lid with water, the seal ring, block proof cover,
exhaust valve core and float valve can be removed for washing, timely and correctly
install them after washing, and then dry the internal side of lid with cloth.
5.
Wipe clean the cooker body with a rag, and it is prohibited to soak the cooker
body in water or spray water to it.
ELECTRICAL SCHEMATIC DIAGRAM
TROUBLESHOOTING
When followings occur, it is not the cooker fault, please carefully check once before sen-
ding it for repair.
S/N
Problem
1
Difficult to close the lid
2
Difficult to open the lid
3
Steam leaks from the lid
Reason
Sealing ring not installed properly
The floater valve clamps the push rod
Float valve in the popped-up position
Pressure exists inside the cooker
Sealing ring installed improperly
Food debris attached to the sealing
Sealing ring damaged
The lid is not closed correctly
Solution
Position the sealing ring well
Lightly push the push rod
Press the float valve lightly with a chopstick.
Open the lid after the pressure is completely
released.
Install the sealing ring as required
Clean the sealing ring
Replace the sealing ring
Close the lid correctly
39
Tabla de contenido
Solución de problemas
