Switching On And Off; Changing The Tool - KRESS FME 1101 Manual Del Usuario

Operation
Operation
The tool runs on for a short time after
it is switched off.
If there is contact between the tool
and the support surface, there is a
danger of losing control of the
machine.

Switching On and Off

To switch on the machine, push the On/Off switch
5 forward and press it down at the front to lock on.
To switch off the machine, press down the On/Off
switch 5 at the rear so that the switch springs back
to the off position.
Preselect speed (Option)
In devices with a setting dial 6, you can select the
speed using the setting dial 6 depending on the
area of application.
800FME / 1050FME 1050FME-1
1
10.000 min
2
12.600 min
3
17.000 min
4
21.000 min
5
25.000 min
6
29.000 min

Changing the tool

Disconnect the plug from the power
source before making any adjust-
ments, changing accessories, or stor-
ing power tools.
Such preventive safety measures
prevent accidental start of the power
tool.
Wear safety gloves for tool chang-
ing.
The tool insert can become very hot
after working for long periods and/or
the cutting edges of the tool insert
are sharp.
Clamping the tools
The spindle 3 of the milling and grinding motor is
equipped with a precision collet chuck 2 to hold
the tools. A spindle lock enables you to tighten
and loosen the locknut 1.
-1
5.000 min
-1 -1
7.700 min
-1
12.500 min
-1
16.500 min
-1
21.000 min
-1
25.000 min
To clamp the tool, you lock the spindle 3 by
pressing the locking button 4.
You tighten the locknut 1 using a SW 17
open-ended spanner.
When you unclamp the tool, the spindle 3 in
turn is locked.
You loosen the locknut 1 by turning the open-
ended spanner. You can remove the tool by
continually turning the open-ended spanner.
Operating tips
Working with the milling motor
-1
When you use a drill stand or a mill/drill unit (pos-
sibly with a milling table), you must refer to the
-1
notes in the instructions for use provided there.
-1
Also note that you must add the alignment fences
-1
as far as possible on the milling cutter, the hand
-1
deflector (screen) must be set down as tightly as
possible on the workpiece surface and, for milling
work, you must always use equipment that can
guarantee safe use of the tool, for example, align-
ment fence, auxiliary bearings, automatic feeders
or a non-return block for milling work.
The feed direction of the tool must always be the
opposite of the circulation direction of the milling
cutter (counter direction):
Attention! After you use the insertion
tool, perform a test run with an over-
speed and make sure that no-one is
within reach of the rotating insertion
tool. Damaged tools usually break in
this test period.
Wear protective glasses and hearing
protection.
Caution! Always mill in a counter
direction!
English 19
EN
FME-EN / 1101