Technical Data; Troubleshooting - Lelit PS11N Manual De Instrucciones

TECHNICAL DATA:

Adjustable iron thermostat set from 0°C to 215°C
Bimetallic safety iron thermostat with manual reset at 275°C
Heating element: 800W
Boiler power: 1150W
Thermostat for no water: 180° C
Safety Thermostat: 298°C
Working pressure: 2,5 bar
Max. pressure: 5,5 bar
Tank nominal capacity: 1,2 litres
Voltage: 230V:50Hz (120V:60Hz)

TROUBLESHOOTING:

PROBLEM
It may happen that, while filling
You don't get much the tank, some water spills over
steam from the the cap and flows inside the
boiler appliance
insulating material
While filling the tank you may
have poured too much water into
From the iron you
it.
get steam mixed
with water
The iron plate is not hot enough.
The iron switch (2) might be off
The iron does not
produce any steam
The boiler switch (3) might be off
There might be no more water
left in the tank
The ironing board cover might
not be able to absorb the steam
completely
The ironing board
gets wet
The
mixed
spraying some steam on a dry
cloth)
The iron releases Maybe some dirty water might
dirty water have gone into the tank
The inserted data and pictures can be subject to changes without previous notice for the improvement of the
machine's performances.
CAUSE
body wetting
steam iron leaks steam
with water (check
We suggest using the machine as usual so to dry up
the insulating material through the heat of the
machine. In case you still have this problem after one
the
working hour, please contact the service center
Please empty the tank. Let all the steam go out as
described in the manual before opening the cap.
Please check that the temperature knob is on the
right position: "cotton °°°"
Press the iron switch; wait for 4 minutes so that the
iron plate warms
Press the boiler switch: wait for 10 minutes so the
boiler produces steam.
Fill it to with water following the instructions
carefully.
You might use a thicker cover (or two covers) so to
create a thicker surface to absorb the steam better.
In case you are using a vacuum table, switch on the
vacuum function each time you are using the steam
by
See above described procedure
Fill the empty tank with 1 liter of tap water, screw
the cap up, shake the machine, open the cap and
empty the tank. Repeat the action until the water
results clean. Before ironing again release some
steam on a cloth, until clean steam comes out. We
do not recommend the use of any additive.
ENGLISH
SOLUTION
Pag. 5