Lelit PS11N Manual De Instrucciones página 4

COMPONENTS:
1. Safety cap
2. Iron switch
3. Boiler switch
USER INSTRUCTIONS:
1. Remove the ironing machine from its packing and make sure all packing parts have been taken off
(including the protection bags). Lay the machine on a flat and steady surface fitted to support it, next to
a wall socket (max. mt. 1,5).
2. Unscrew the safety cap (1) and let the internal air out. Fill the boiler with max. 0,9 litre of water,
making sure you do not overfill the tank.
3. Close the safety cap (1). Insert the plug into the main supply point.
4. Press the boiler switch (3) and the iron switch (2).
5. Turn the iron plate's temperature regulating knob (5) to the position "cotton °°°" (indicated on the iron
knob).
6. Wait that the boiler switch indicator light (3) goes off (it takes about 10 minutes). While ironing, the
boiler switch indicator light (3) may come on again.
7. The machine is ready for use.
8. Press the steam switch (4).
9. When you first press the steam button you might notice a decrease in pressure. In order to have plenty
of steam wait till the boiler switch indicator light (3) goes off.
10. In case the steam stops during ironing, it means that there is no more water in the tank. To start
ironing again, switch off the boiler switch (3); press the steam iron button (4) to ensure there is no
more steam in the boiler, switch off the iron switch (2) and unplug the machine.
11. Slowly open the pressure cap (1) and check that there's no more steam coming out of it. Wait a couple
of minutes and then refill the tank with possibly warm water. Restart from point 3.
CAUTION:
Do not leave the machine unattended while the plug is connected to the socket.
-
The iron reaches very high temperatures and it keeps being very hot even 15 minutes after it's been
-
switching off. Be careful not to burn yourself.
For complete safety, before filling the boiler, please disconnect the plug.
-
While using the machine, never unscrew or remove the cap while under pressure (1). Before removing
-
it, make sure that it does not release steam anymore from the iron.
The machine has a special safety system. Only qualified technician should replace it.
-
The safety cap (1) must be replaced with original parts only.
-
PLEASE NOTE:
The use of normal tap water is recommended. In order to clean the boiler and remove limestone, rinse it
internally (every 15-20 litres of water used or every month) with tap water.
Pag. 4
4. Steam button
5. Iron plate temperature regulating knob
ENGLISH