ELICA Up Montaje Y Modo De Empleo página 14

Maintenance
Warning! Before any cleaning or maintenance operation,
disconnect the hood from the mains by removing the plug
or disconnecting the main switch of the house, or by
pressing the red button inside the hood, above the grease
filters.
Cleaning
The cooker hood should be cleaned regularly (at least with the
same frequency with which you carry out maintenance of the
fat filters) internally and externally. Clean using the cloth
dampened with neutral liquid detergent. Do not use abrasive
products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning
recommendations of the cooker hood and replacement of the
filters may cause fire risks.
Therefore, we recommend observing these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate
maintenance or failure to observe the above safety
recommendations.
Panel
Panel replacement
The panel replacement is done by first opening it as indicated
in chapter opening panel; in the case of the LIGHT panel, you
must disconnect the power from the mains and unplug the
power cord of the lamps by acting on the electrical connector
located right above the panel.
Remove the two locknuts securing the panel (see fig. 12) and
slide the panel to the right to remove it from its seat.
To place the panel back into position, follow the above
described procedure in reverse order.
Grease filter
Traps cooking grease particles.
This must be cleaned once a month (or when the filter
saturation indication system – if envisaged on the model in
possession – indicates this necessity) using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
The grease filters installation and removal is done by opening
the panel as described in section "Panel Opening."
Charcoal filter (filter version only)
It absorbs unpleasant odours caused by cooking.
The saturation of the charcoal filter occurs after more or less
prolonged use, depending on the type of cooking and the
regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least
every four mounths.
The charcoal filter may NOT be washed or regenerated.
Replacing lamps
Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs ensure they are
cooled down.
To replace the damaged fluorescent lamps you must unplug
the product from the mains, then open the panel by following
the instructions in the chapter "PANEL OPENING".
Remove the six perimeter screws of the panel and open it as
shown in figure 11; proceed in replacing the fluorescent lamp
using a lamp with the same characteristics.
Put back into position the panel and the screws you previously
removed.
For the replacement of the fluorescent lamps feeder, act in the
same way as described above, since the feeder is positioned
next to the lamps.
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
14