Assembling The Wireless Speaker Stand; Stand Assembly - Acoustic Research WHT24 Manual De La Instalación Y De La Operación

Assembling the Wireless Speaker Stand

The speaker stand comes in two
parts, with the speaker wire already
threaded through both poles. Please
be careful when unpacking to ensure
that the wire remains threaded
during assembly. To assemble the
speaker stand:
1. Attach the Top Pole to the
Threaded Bottom Pole by twist-
ing the Locking Sleeve Nut over
the bottom pole.
2. Attach the speaker pole to the
Receiver Base. The pole is a key
fit and will only turn in one
direction.
3. Tighten the pole to the Receiver
Base using the supplied Hex
Nut.
4. Attach the speaker by inserting
the top of the speaker rod
through the holes on the back of
the speaker. The top of the rod
should be flush with the top of
the speaker.
5. Connect the Speaker Wire using
the proper polarity (positive to
positive, negative to negative).
NOTE: When properly assem-
bled, the speaker wires should
run through the center of the
stand assembly, with one end
coming out through the hole near
the top and the other end through
the bottom of the receiver.
NOTE: Move the rubber grom-
met to adjust the height of the
speaker stand.
FIGURE 4 - Speaker

Stand Assembly

HT60
Surround Speaker
Upper/Top Pole
Speaker Wire
Locking Sleeve Nut
Rubber Grommet
Threaded
Bottom Pole
Speaker Wire
Receiver Base
Hex Nut
page 7
WHT24
ON OFF
L AUDIO R
OFF DC IN
LINK