Connecting A Hunter Remote; Connecting To A Hunter Remote (Not Included); To Install The Smartport Connector; Power Failures - Hunter X-CORE Manual Del Usuario

CONNECTING A HUNTER REMOTE

Connecting to a Hunter Remote (not included)

The X-Core Controller is compatible with Hunter Remote Controls
(not included). The SmartPort
Hunter Remotes) allows for fast and easy use of the Hunter controls.
The Hunter remotes make it possible for you to operate the system
without having to walk back and forth to the controller.

To install the SmartPort connector

1. Install a 1/2" Female threaded "Tee" in
the field wiring conduit (not included)
approximately 12 inches below the
X-Core.
2. Feed the red, white, and blue wires
of the harness through the base of
the "Tee" and into the wiring
compartment as shown.
3. Screw the SmartPort harness
NOTE: P/N 258200 can be used as
an alternate method to mount the
SmartPort connector.

POWER FAILURES

Due to the possibility of power failures, the controller has non-volatile memory. Programmed information will never be lost due to a power
outage. The lithium battery will keep the correct time without AC power. Normal watering will resume when AC power is restored.
® wiring harness (included with all
To Controller
1 / " Thread
2
Pre-assembled
housing into the "Tee" as shown.
4. Attach the red, white, and blue SmartPort wires to the
controller terminal as shown below:
• Red wire to left side "24 VAC" terminal
• White wire to right side "24 VAC" terminal
• Blue wire to "REM" terminal
24VAC
Assembled
red blue
white
SEN C P 1 2 3 4 5 6 7
EN
8
19