Installation Instructions - Deltaplus TRA20 Manual De Instrucciones

INSTALLATION INSTRUCTIONS

FOR ANCHOR DEVICE TRA20，TRA30，TRA22，TRA32
1: Pull out the safety pins
Figure 1
1: Adjust the feet to the working position
2: Open legs
3: Insert safety pins
Figure 2
A: Flat
B: Soft ground
1: Pull out position pins
2: Adjust the height
3: Insert position pins
Figure 3
!: 3 legs should be on the same height
4: Adjust the webbing to have the legs well tightened
1: lock the winch plate with bolts
2: raise the winch plate
3: Raise the winch plate so as to drive the rotation of the pin
Figure 4
4: put the winch plate on the leg
5: raise the winch plate and insert the pin
1: put one side of the retractable system on the retractable system plate
2: put other side on the retractable system plate
Figure 5
3: Insert the pin
1: raise the retractable system plate
2: Raise the retractable system so as to drive the rotation of the pin
Figure 6
3: put the retractable system plate on the leg
4: raise the retractable plate and insert the pin
1: Put the handle
Figure 7
!: Use only in relief
1: Put the step alignment on leg holes and insert the pin
2: revolve the step
Figure 8
!: Under normal circumstances, the step put on the leg which is no pulley
1: Pull out the pin and put the cable on the pulley
2: Insert the pin
Figure 9
!: If you cannot reach the pulley ,use the steps
Anchor point one the leg.
Figure 10
Retractable system can be used as anchor point.
Anchor point on the head
There is three anchor point on the head
Anchor point on the head can be used with user fall arrest device such as retractable
Figure 11
system.
!: Each anchor point for single use only,three anchor points can be used at the same
time.
B.P. 140 - ZAC de La Peyrolière
84405 APT CEDEX - FRANCE
("TRIPOD ")
These two steps can be exchanged
TRAxx Anchorage device UPDATE : 12.02.2016
EN
Page 62/62