Horizon Global 76386 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
4
3
Fasteners
typical on
both sides
Conical Washer
Teeth side
Against hitch
1. Loosen lower fascia - Using T15 torxbit, remove (3) screws from bottom of lower fascia. Return (1) screw to vehicle owner.
2. Feed fasteners – (a) Using a flat head screwdriver, remove (2) clips of wiring cable from side of both frame rails. (b) Using utility knife, remove the caulking area as
shown in Figure 3. (c) Feed the carriage bolts ① and washers ② through access holes on both side frame rails using the pull wires ⑤, see Figure 1 & 2. Leave pull wires
attached.
3. Trim lower fascia – Using a tape measure, marker, and utility knife, measure, mark, and trim the lower fascia. See Figure 4.
4. Install hitch - Gently pulling the lower fascia outward, raise the hitch into position and slide it behind the fascia. Feed the pull wires through bracket slots. Remove pull
wires and loosely install conical washers ③, hex nuts ④ to the hitch.
5. Tighten all 7/16-14x1.75 GR 5 fasteners to 50 ft-lb (68 N*m).
6. Reinstall (2) screws on the side of lower fascia.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A
hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a
torch. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2020 Horizon Global Americas Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 76386, 84386, CQT76386
A. Insert bolt and
Block into frame
2
1
Frame
Rail
Figure 2
B. Align block on C. Pull bolt
access hole thru block
Figure 1
Access
hole
7 "
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Sheet 3 of 18
Fastener Kit: 76386F
① Qty. (4) BOLT CAR 7/16"-14X1.75 GR5
② Qty. (4) WASHER
0.88 X 2.00 X .109
③ Qty. (4) WASHER CONICAL 7/16"
④ Qty. (4) NUT 7/16"-14 GR2
⑤ Qty. (4) Pull wire 7/16-14
Figure 3
C
of Vehicle
L
1 "
Figure 4
76386NP 11-25-20 Rev. A