Power Supply - Sangean DT-220 Instrucciones De Manejo

Power Supply

The set can be operated by
- Two 1.5V batteries (IEC 46 or UM-3 or AA sizes)
- DC 3V power adapter (not supplied) to connect to 3V
DC jack Connector plug 6 mm dia., negative pole
inside (center negative) .
Insert two 1.5V batteries into the battery compartment.
Make sure they are right way round.
Note: If display appears low battery symbol
the battery. Run-down batteries should be
removed from the set right away because of the
risk of leakage.
If the set is not going to be used for a longer period,
batteries should also be removed.
Time Set
The first time after batteries are installed , display will
show 0:00 and second starts to count.
To adjust the time only when radio is off. Press Time
Set button for more than 2 seconds, display time set
11
icon also hour digit will flash. Press Tuning up/down
button to set the hour then press Time Set button
9
again to set the minute. Press Time Set button again to
finalize time setting. The clock will start from 0 second .
4
, replace