Via Benini, 1 - 40069 - Zola Predosa - BOLOGNA - ITALY Declares that: Operator mod. 391 - 391 E • is built to be incorporated in a machine or to be assembled with other machinery to create a machine under the provisions of Directive 98/37/EC;...
° 0 ° 5 crushing clutch, means that a control unit with an adjustable electronic clutch device is necessary. • The 391 automated system was designed and built for controlling vehicle access - do not use for any other purpose. >...
4. ELECTRICAL CONNECTIONS • If the thrust values are not within the values specified in UNI EN12453 standard, the zone indicated in figure 4 MUST be protected with a protective device • The lay-out below refers to an installation with two conforming to the UNI EN12978 standard.
Establish the height of the Secure the bracket in the established position using two M8 operator, bearing in mind that: screws. • the securing bracket of the curved arm must be in a zone where it can be secured to the gate leaf (Fig.7) •...
7. MANUAL MODE OPERATION 5.5. POSITIONING THE MECHANICAL STOPS The 391 operator is supplied standard with opening and closing mechanical stops. This is to facilitate the installation operations If the operator has to be manually activated due to a power...
Página 7
9) FAAC is niet aansprakelijk als de regels der goede techniek niet in acht genomen HINWEISE FÜR DEN INSTALLATIONSTECHNIKER zijn bij de bouw van het sluitwerk dat gemotoriseerd moet worden, noch voor ALLGEMEINE SICHERHEITSVORSCHRIFTEN vervormingen die zouden kunnen ontstaan bij het gebruik.
Página 8
6) FAAC declines all liability caused by improper use or use other than that for which 23) Eloigner de la portée des enfants les radiocommandes ou tout autre générateur the automated system was intended.
Página 9
Les descriptions et les illustrations du présent manuel sont fournies à titre indicatif. FAAC se réserve le droit d’apporter à tout moment les modifications qu’elle jugera utiles sur ce produit tout en conservant les caractéristiques essentielles, sans devoir pour autant mettre à...