Configuration - Leuze electronic CU405-2M12 Manual Del Usuario

Functions
The functionality of the RSL 410 with CU405-2M12 connection unit is limited:
- Safe sensor function with the two OSSD outputs of protective function A
MELD
- non-safe signal output. The
multiple signals via the
For data communication, the following options are available as configuration inter-
face:
- ETH Ethernet communication connection
- Communication via Bluetooth
The following functions of the RSL 410 are not available when using the
CU405-2M12 connection unit:
- EDM
- Start/restart interlock

Configuration

NOTE
Use configuration only for RSL 410 with connection unit CU405-2M12!
 Use the configurations for RSL 410 with connection unit CU405-2M12 only for
scanner units with connection unit CU405-2M12.
Configurations for RSL 410 with connection unit CU405-2M12 may not be
used for scanner units with other connection units.
The RSL 410 is configured for the respective scanner unit independent of the
CU405-2M12 connection unit.
Sensor Studio
- The
configuration restrictions which are caused by the CU405-2M12 connection
unit.
- Configured functions, in which attention has not been paid to the restrictions
that are caused by the CU405-2M12 connection unit, are not available at
runtime. As a result, the switching-on of the OSSDs is prevented or error
messages are output if necessary.
NOTE
Check the function of the safety sensor before commissioning!
 Check the function of the safety sensor before commissioning (see the
operating instructions
MELD
Sensor Studio
configuration and diagnostics software does not monitor
for the RSL 410, chapter 11 "Check").
output can be configured with
configuration and diagnostic software.
EN
original
11