Intended Use; Technical Specifications - Roney Power RPM-550 Manual De Instrucciones

Hammer drill

INTENDED USE

This tool is intended for hammer drilling in brick, concrete and stone as well as for drilling in wood, metal,
ceramic and plastic. Tools with electronic speed control and left/ right rotation are also suitable for crewdriving
and thread cutting

TECHNICAL SPECIFICATIONS

PRODUCT ELEMENTS
1 On/Off switch with speed control
2 Switch locking button
3 Wheel for maximum speed control
4 Switch for changing direction of rotation
5 Switch for selecting drilling function
6 Auxiliary handle
SAFETY
WARNING! Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire
and/or serious injury.
● Wear ear protectors with hammer drills (exposure to noise can cause hearing loss)
● Use auxiliary handles supplied with the tool (loss of control can cause personal injury)
● Avoid damage that can be caused by screws, nails and other elements in your workpiece; remove them
before you start working
● Always keep the cord away from moving parts of the tool
● When you put away the tool, switch off the motor and ensure that all moving parts have come to a complete
standstill
● Use completely unrolled and safe extension cords with a capacity of 16 Amps (UK 13 Amps)
● In case of electrical or mechanical malfunction, immediately switch off the tool and disconnect the plug
● WORLD-PRO TOOLS can assure flawless functioning of the tool only when original accessories are used
● Use only accessories with an allowable speed matching at least the highest no-load speed of the tool
● This tool should not be used by people under the age of 16 years
● Be careful not to drill or drive into areas where electrical wires may be contacted
● If the cord is damaged or cut through while working, do not touch the cord, but immediately disconnect the
plug
● Never use tool when cord is damaged; have it replaced by a qualified person
● Always check that the supply voltage is the same as the voltage indicated on the nameplate of the tool (tools
with a rating of 230V or 240V can also be connected to a 220V supply)
● If the drill bit becomes unexpectedly jammed (causing a sudden, dangerous reaction), immediately switch
off the tool
● Be aware of the forces that occur as a result of jamming (especially when drilling metals); always hold the
tool firmly with both hands and take a secure stance
● Always disconnect plug from power source before making any adjustment or changing any accessory
● Holding the tool
- keep the ventilation slots uncovered
- do not apply too much pressure on the tool; let the tool do the work for you
Your machine is double insulated in accordance with EN60745; therefore no earthwire is required.
MAINTENANCE
Make sure that the machine is not live when carrying out maintenance work on the motor. Regularly
4