Orkli OKSOL Manual De Instalación página 12

EN
• ONLY FOR SMART ELECTRIC RESISTANCE KIT: connect the "Resistance connection" and "Voltage
input connection" cables to the resistance control electronics.
Summary of the final assembly of the SMART electrical resistance kit:
• Drill the cover and fix the supplied M20 cable gland. Pass a power supply cable through and connect it
to the "Power input connection" cable (it is recommended to leave this connection inside the system,
so that it is protected from the outside).
CONNECTOR
Steps for the installation of the cable gland:
1. Cut off part of the
insulation to make a
hole in the side cover.
4. Pass the cable
through so that the
connection is inside
the OKSOL.
12
VOLTAGE INPUT CONNECTOR
CONNECTOR OUTPUT VOLTAGE
TO RESISTANCE
CABLE GLAND M20
NUT
2. Drill hole Ø20.
3. Fit cable gland with
nut.