Product Characteristics - YATO YT-85710 Manual De Instrucciones

PRODUCT CHARACTERISTICS

The industrial vacuum cleaner is used for cleaning workplaces from dry and wet impurities, which would not be handled by a
household vacuum cleaner. It can also be used for extracting the dust generated when working with other power tools. Thanks
to the capacious container, fl exible hose, it is possible to reach hardly reachable places and clean them thoroughly. The base
fi tted with casters enables easy transport of the vacuum cleaner. The vacuum cleaner has been fi tted with replaceable air fi lters.
Correct, reliable and safe operation of the product depends on proper operation, therefore:
Before starting the work with this tool, please read this manual and keep it properly.
The supplier does not assume any liability for damages resulting from failure to follow safety regulations and recommendations
specifi ed in this manual.
PRODUCT ACCESSORIES
The product is delivered complete and does not require assembly. The product has been delivered with: fi lters, the fl exible hose,
extension pipes and two suction nozzles: wide and narrow.
TECHNICAL DETAILS
Parameter
Catalogue number
Mains voltage
Mains frequency
Rated power
Operating vacuum
Container capacity
Insulation class
Protection class
Weight
GENERAL SAFETY CONDITIONS
The device can be used by children aged 8 and older and people with reduced physical, sensory or mental ability, also by people
lacking experience and knowledge, if they are supervised and received instructions how to use it safely, and understand the
hazards.
Supervise children so that they do not play with the device. Cleaning and maintenance should not be performed by children
unattended.
The vacuum cleaner is designed for dry and wet cleaning. Before the start of work involving the sucking of water or wet impurities,
please follow recommendations included in this user instruction. Failure to comply with them may result in electric shock, which in
turn may pose a threat to health and life of the user and third parties.
Suction of other wet impurities than water is forbidden. Suction of paints, oils, solvents, gasoline and other fl ammable substances
can lead to irreversible damage to the vacuum cleaner or its components, and may also pose a threat of electric shock, fi re or
explosion.
Before changing the type of work, always empty, clean and dry the vacuum cleaner container. Impurities remaining in container
after the previous work may disturb the operation in case of changing its nature.
Never suck in hot, glowing or burning objects. This can lead to fi re or explosion and expose the user to serious injury or death. The
maximum temperature of impurities sucked in cannot exceed 40 degrees centigrade.
The device is intended for work in confi ned spaces and should not be exposed to water, including atmospheric precipitation.
Prior to connecting the power cord plug to the vacuum cleaner, make sure that mains parameters correspond with parameters
indicated on vacuum cleaner's data plate.
Prior each use, please check the condition of the device, including power cord and plug. If any faults are found, do not use the
device. Damaged cables and cords must be replaced with new ones in a specialist workshop.
The degree of protection given in the table with technical data is ensured if the device will be connected to a socket with at least
the same degree of protection.
Prior to maintenance of the device please make sure, that the power cord plug was disconnected from the mains socket.
The device should be stored in a place inaccessible for third parties, children in particular. Also during the work please note, that
the device is out of reach of unauthorised persons, children in particular.
Carry the device using the handle, do not move the device by pulling the power cord.
In case the vacuum cleaner is used as a blower, it is forbidden to direct the hose outlet towards people and animals.
Check the condition of connector on a regular basis. It is forbidden to use the vacuum cleaner with the hose damaged.
O R I G I N A L
GB
Measuring unit
[V~]
[Hz]
[W]
[kPa]
[l]
[kg]
I N S T R U C T I O N S
Value
YT-85710
220-240
50/60
2400
18
70
II
IPX4
6.7
11