Cooper Lighting RFM182 Instrucciones página 5

RFM182_W 825-0255.qxd:Layout 1
4. Connect lampholder wires to supply wires from house (white to white and black
to black) using wire nuts included.
5. Attach the mounting plate to your junction box using screws included, making
sure that the gasket is properly aligned and that all screws are tightly secured.
To prevent moisture from entering the junction box, apply a bead of silicone
sealant around the edge of the mounting plate where it attaches to the
junction box.
6. Screw bulbs into each lampholder (do not over tighten bulbs).
7. Turn power ON at the main fuse/breaker box.
HOW TO OPERATE YOUR FIXTURE
1. Make sure both fixtures are set to the same house code
(fixtures will come from factory already set to the same
code). You may reset the house code by turning the dial
(recessed slot) on the bottom of the sensor head and the
bottom of the remote light to the same number (Fig. 4).
There are 16 different selections.
2. Move slide switch on bottom of sensor head to TEST.
Set sensitivity knob to medium (halfway).
3. Turn ON power to both fixtures.
4. Aim sensor head toward desired detection area. Make
sure sensor head is positioned with the control switches
facing towards the ground and at a 15º down angle.
WARNING: Be sure to maintain a 1˝ air spacing between the sensor
head and mounting surface.
5. Walk across the detection zone at the farthest distance you wish your detector
to detect motion. Adjust sensitivity until you get desired results.
6. Move slide switch to 4 MIN. or 12 MIN. (AUTO mode). At dusk, lights will
operate in the AUTO setting.
Call for customer service and/or missing or damaged parts (800-334-6871)
11/13/08 10:09 AM Page 5
5
Fig. 4