Elcometer 500 Guia Del Usuario página 12

7 SETTING THE GAUGE PARAMETERS (continued)
None; No information is displayed.

Readings (Figure 5); The reading value

is displayed using the resolution as
defined by the user, see Section 7.7 on
page en-13.
Statistics - Model B (Figure 6); The

following statistical values are displayed
as each measurement is taken:
Number of Readings, Mean, Lowest Reading,
Highest Reading, Standard Deviation,
Coefficient of Variation.
To clear the current statistical values,
press Display\Clear Statistics.
Selected Statistics - Model T (Figure 7);

Up to 8 statistical values can be
displayed as defined by the user via
Display/ Statistics/ Select Statistics.
Select from:
Number of Readings, Mean, Lowest Reading,
Highest Reading, Standard Deviation,
Coefficient of Variation, Low Limit Value,
Number Below Low Limit, High Limit Value,
Number Above High Limit, Range, NDFT
(Nominal Dry Film Thickness) Value.
To view the current statistical values,
press Display/Statistics/View Selected or
View All.
To clear the current statistical values,
press Display/Statistics/Clear Statistics.
Run Chart - Model T (Figure 8); A line

trend graph of the last 20 measurements
which is updated automatically after each
reading.
Bar Graph - Model T (Figure 9);

An analogue representation of the
current measurement value together
with the highest (Hi), lowes
average (
X
updated automatically when each
reading is taken.
en-11
R
) reading. The graph is
t (Lo) an d
Figure 5: Readings
Figure 6: Statistics
& Readings (Model B)
Figure 7: Selected Statistics
& Readings (Model T)
Figure 8: Run Chart &
Readings
Figure 9: Readings &
Bar Graph
www.elcometer.com