Ecco 10 Serie Instrucciones Para El Montaje página 2

12-Series Lightbar Roof Mounting Kits
1. Remove mounting foot. Position bracket onto knubs of the foot.
2. Holding the bracket and foot together, insert the cage nut as shown. The fit will be snug under the mounting foot. Do not install it on the
outside face.
3. Install the mounting feet in reverse order of their removal. The metal bracket will be sandwiched between the lightbar and the composite
mounting foot. Adjust the spacing of the mounting feet before securely tightening the nuts.
4. Hand thread the M6 bolt through the star washer and mounting strap into the cage nut. Be careful not to cross thread the bolt, and
leave loose until later steps.
5. Once the bar is in position, use the strap as a template to drill Ø1/8" holes. It may be necessary to pull back the door sealing gasket or
trim. Apply silicone or sealant around the hole, behind the strap. Secure the straps with the provided #10 stainless steel sheet metal
screws with washers as shown. Screws should be tightened around 5-10 in-lb.
6. Tighten the M6 bolts evenly so that the bar is even and centered. Reinstall any removed trim and/or weather-stripping and close doors
to check secure fit of the lightbar.
M6 SCREW
MOUNTING
STRAP
#10 STAR WASHERS
SHEET METAL SCREWS
920-0060-00 Rev. C
LIGHTBAR
MOUNTING FOOT
M6 STAR WASHER
Ø1/8" HOLES
5/16" HEX BOLTS
5/16" SPLIT LOCK WASHERS
VEHICLE ROOF
FOOT BRACKET
M6 CAGE NUT
5/16" FLAT WASHERS
5/16" HEX NUTS
Page 2 of 3