Cleaning And Maintenance - Medel PROFESSIONAL Manual Del Usuario

EN
9. Plug the device into the wall socket, making sure that the
main supply corresponds to the electrical rating of the de-
vice.
10. To start the treatment, set the I/O switch into the "I" position.
! ATTENTION: this device is for continuous use.
11. Inhale the aerosol solution using the prescribed accessory.
12. When the treatment has been completed, switch the unit off
by setting the I/O into the "O" position and disconnect the
plug from the wall socket.
13. Wash the nebulizer and its accessories as described in the
"CLEANING AND DISINFECTION OF THE ACCESSORIES" section.
14. The device requires no calibration.
15. No modification to the device is permitted.
INSTRUCTIONS FOR USE OF THE ACCESSORY CASE WITH
ANING SYSTEM
Pull out the accessory case from the device and open the lid.
Put all the accessories (except for the air tubing) inside the acces-
sory case.
For cleaning operations follow the sterilizing solution manufac-
turer's instructions. Close the lid and proceed with the cleaning.
For the liquid elimination keep closed the lid and turn upside
down the accessories case; the liquid will come out from the wa-
ter drain holes place on the lid.
26
100024_MedelProfessional_USERmanual_REV.02.indd 26-27

CLEANING AND MAINTENANCE

The cleaning of the device must be carried out by using a soft and
dry cloth and non-abrasive cleansers.
!
ATTENTION: during cleaning operations, make sure the
internal parts of the unit are not in contact with liquids and
that the power plug is disconnected.
CLEANING AND DISINFECTION OF THE ACCESSORIES
!
Follow carefully the cleaning and disinfection instructions
of the accessories as they are very important for the device
performances and the therapy success.
1.First use and after each treatment:
Disassemble the nebulizer by turning counterclockwise the top
and remove the medicine conduction cone. Wash the compo-
nents of the disassembled nebulizer, the mouthpiece, the masks
CLE- and the nosepiece by using tap water; dip in boiling water for 5
minutes. Reassemble the nebulizer components and connect it
to the air-outlet (Pic.G), switch the device on and let it work for
10-15 minutes.
!
Do not boil nor autoclave the air tube.
2.Sterilization:
Cold disinfecting liquids may be used instead of boiling water,
following the manufacturer's instructions.
EN
27
28/06/2017 10:21:11