Application
Operation is possible in conjunction with:
• Pressurized storage heaters
• Thermally controlled instantaneous heaters
• Hydraulically controlled instantaneous heaters
Operation with low-pressure storage heaters
(displacement water heaters) is not possible.
Specifications
• Max. flow
• Flow pressure
- min.
- recommended
- greater than 72.5 psi, fit with pressure reducing
valves
• Max. operating pressure
• Test pressure
• Temperature
- max. (hot water inlet)
- Scalding protection possible by fitting a handle
rotation stop (see replacement parts fold-out
page II, order no. 46 308).
• Water connection
Notes
• An access panel must be provided for access to the
hose connections.
• Major pressure differences between cold and hot
water supply should be avoided.
Installation
Layout dimensions to establish centers and proper
clearences, see dimensional drawing on fold-out
page I.
Flush pipes thoroughly!
Installing faucet body
- Fit faucet body (A) with mounting set (B), see fold-
out page III, fig. [1].
Installing spout
1. Fit shank (C) with mounting set (D), see fig. [2].
2. Fit spout (E) to the shank (C), tighten set screw (F)
with 4mm hexagon key and screw on cover cap (G),
see fig. [3].
1
approx. 24 l/min or 6.3 gpm
7.25 psi
14.5 - 72.5 psi
145 psi
232 psi
176 °F
cold - Right hand
hot - Left hand
English
Connecting the faucet, see figs. [4] and [5].
The hot water supply should be connected on the left,
the cold water supply on the right side.
Open cold and hot water supply and check
connections for leakage.
Operation
Pull lever
Press lever down
Turn lever right
Turn lever left
Maintenance
Inspect and clean all parts, replace as necessary and
grease with special grease (order no. 18 012).
Shut off cold and hot water supply!
I. Replacing the cartridge, see fig. [6].
1. Lever out plug (H).
2. Loosen set screw (J) with 3mm hexagon key and
pull off lever (K).
3. Unscrew cap (L).
4. Remove screws (M).
5. Replace complete cartridge (N).
Assemble in reverse order.
Observe the correct installation position.
Make sure that the cartridge seals engage in the
grooves on the housing. Fit screws (M) and tighten
evenly and alternately.
II. Unscrew and clean flow straightener (13 907), see
fold-out page II.
Assemble in reverse order.
Replacement parts, see fold-out page II ( * = special
accessories).
Care
Instructions for care of this faucet will be found in the
Limited Warranty supplement.
= open (water flow)
= closed
= cold water
= hot water
