Technical Specifications; Troubleshooting - STEINEL PROFESSIONAL IR 180 UNIVERSAL Manual Del Usuario

Light function
DIP switch 2 Switch
mode configuration DIP
switch 4
Fully automatic -
mode (AUTO)
Fully automatic ON-OFF
mode
Fully automatic ON
mode
Semi-automatic -
mode (MAN)
Semi-automatic ON-OFF
mode
Semi-automatic ON
mode
Status Switch function
Lighting is Lighting is switched
switched OFF ON for the stay-ON
time selected.
Lighting is Lighting is switched
switched ON OFF for the stay-ON
time selected and
re-triggered on
detecting movement
(inverse mode /
presentation mode).
Lighting is The stay-ON time se-
switched ON lected is re-triggered.
Lighting is Lighting is switched
switched OFF ON for the stay-ON
time selected.
Lighting is Lighting is switched
switched ON OFF until it is next
activated.
Lighting is The stay-ON time se-
switched ON lected is re-triggered.
- 24 -
8� Technical specifications
Dimensions W x H × D
Supply voltage
Sensor system
Reach
Angle of coverage
Capacity, switching output 1
Minimum connected load
Light-level setting
Time setting
Mounting height (minimum)
IP rating
Temperature range
9� Troubleshooting
Malfunction Cause
Light does not switch ON n No supply voltage
n Lux setting too low
n No motion being
detected
Sensor responds n State of charge not
when it should not
sufficient
80 × 80 × 50 mm
220-240 ~V / 50/60 Hz
Passive infrared (IR)
max. 20 m
180°
Relay 230 V
max. 200 W resistive load (cos φ = 1)
max. 6 fluorescent lamps /
LED lamps C < 132 µF
max. 100 VA (cos φ = 0.5)
3.5 W
2-1000 lux, ∞ / daylight
30 s - 15 min
1.1 m
IP20
0°C to + 40°C
Remedy
n Check supply voltage
n Slowly increase lux set-
ting until light switches
ON
n Ensure unobstructed
sensor vision
n Check detection zone
n With a very low state
of charge, lighting is
switched ON irrespec-
tive of movement, see
SuperCap charging
behaviour
- 25 -