(En) Step 2: Controls - Behringer ULTRABASS BXD3000H Guia De Inicio Rapido

(EN) Step 2: Controls

(1) The POWER switch turns the amplifier on.
(2) Connect your bass guitar to the INPUT jack using
a ¼" mono plug (unbalanced).
(3) The GAIN 1 knob adjusts the input gain for
channel 1.
(4) The CH 2 button switches between channel 1
and channel 2. This can also be done using the
included footswitch.
(5) The GAIN 2 knob adjusts the input gain for
channel 2. As you turn the knob clockwise,
the distortion effect is continuously blended in.
(6) The SHAPE knob adjusts which frequencies are
scooped out of your bass tone. It only affects
channel 2.
(7) The LEVEL knob adjusts the volume of channel 2.
Use this control to balance the volume between
channels 1 and 2.
(8) The FBQ EQUALIZER has 7 slide controls, one for
each frequency band. The maximum boost/cut
is 12 dB.
(9) The FBQ switch activates the FBQ
spectrum analyzer. The control LEDs, normally
identical when FBQ is off, now show the
energy content of each frequency band
with a corresponding degree of brightness.
The equalizer is always active regardless of the
FBQ function.
(10) The COMPRESSOR knob controls the
compression intensity.
(11) Push this ON button to activate the compressor
for both channels. The LED in the button will
light up to indicate the compressor is on.
(12) The ULTRABASS control allows you to add
ultra-low frequencies one octave below your
bass signal. The ULTRABASS effect is available
for both channels.
Quick Start Guide
(13) Push this ON button to activate the
ULTRABASS function. The LED in the button will
light up to indicate ULTRABASS is on. You can
also control this effect with the included
footswitch.
(14) Use the MASTER control to set the
overall volume.
(15) The PHONES jack is for connecting a
pair of headphones.
(16) Power is supplied via the included IEC connector.
(17) Use the balanced DIRECT OUTPUT (XLR) to route
the audio signal from your BXD3000H to the
input on a mixing console.
(18) Connect your BXD3000H to an external speaker
using a speaker cable connected to the SPEAKER
OUTPUT jack.
(19) Connect the SEND jack to the input on your
effects device. Connect the output on the effects
device to the RETURN jack on the BXD3000H.
(20) The CD IN jacks (RCA) allow you to connect an
external stereo signal. For example, you can
play along with music from a CD or MP3 player.
(21) Send your signal (before the power
amp stage) via the LINE OUT jack with a
¼" mono cable (unbalanced).
(22) Connect the included footswitch to the
FOOTSW(ITCH) jack to switch between
channels and activate/deactivate the
ULTRABASS function.
15