Setup Remote Sensor; Remote Sensor Signal - Oregon Scientific AWS899 Manual De Instrucciones

SETUP REMOTE SENSOR

1. Open the battery compartment with a small Phillips
screwdriver.
2. Insert the batteries.
3. Set the channel and radio signal format. The
switches are located in the battery compartment.
SWITCH
Channel
Radio Signal Format
4. Press RESET. Then set the temperature unit.
SWITCH
Temp
OPTION
If you are using more than one
sensor, select a different
channel for each sensor.
EU (DCF) / UK (MSF)
OPTION
˚C / ˚F
5. Close the battery compartment and place the
sensor in your desired location.
For best results:
• Insert the batteries and select the channel before
you mount the sensor.
• Place the sensor out of direct sunlight and moisture.
• Do not place the sensor more than 30 metres (100
feet) from the main (indoor) unit.
• Position the sensor so that it faces the main (indoor)
unit, minimizing obstructions such as doors, walls,
and furniture.
• Place the sensor in a location with a clear view to
the sky, away from metallic or electronic objects.
• Position the sensor close to the main unit during
cold winter months as below-freezing temperatures
may affect battery performance and signal
transmission.
You may need to experiment with various locations to
get the best results.

REMOTE SENSOR SIGNAL

Initial reception takes 2-10 minutes, and is initiated
when you first setup the unit, and whenever you press
RESET. Once complete, the reception icon will stop
blinking and show the signal strength by displaying
between 1 and 4 waves.
7