Ingco MG1309 Guia Del Usuario página 7

The chart below lists the description, use speed and scope for some of the small articles
supplied together with the tool by category. To achieve best performance of the tool, it is
strongly recommended that you read it prior to operation, failure to adhere to this may
cause accessories to fail.
NOTE!
ALWAYS: Wear eye protection
Insert the shaft FULLY into the collet
Use ONLY up to the speeds stated below
TOOL
Grinding Stones
Various head styles,
on shafts
Diamond Bits
Various head styles
Polishing Wheel
Mounted to polishing wheel
holder (item 14, dia 1)
Sanding/Cutting Discs
Mounted to tool holder
(item 12, dia1)
Note:
DO NOT over tighten screw
Sanding Drum
Mounted on drum holder
Note:
To fit the drum, firstly loosen the small screw on top of the drum
holder this will allow the rubber to relax. Slide the sanding drum onto
the holder.
To secure, simply tighten the screw and the rubber drum will swell,
gripping the sanding drum.
Use to lock flexible shaft when loosening or tightening collet nut of
flexible shaft.
DESCRIPTION
7|English
SPEED
Full speed
30,000/min
Full speed
30,000/min
Half speed
15,000/min
Half speed
15,000/min
Full speed
30,000/min
FOR USE ON:
Metal
Mild steel
Wood Zinc
Plastic Nickel
Copper Mild steel
Aluminium Metal
Metal
Mild steel
Metal
Mild steel
Wood
Metal
Mild steel