Tabla de contenido
Installation
As shown in Figure 8, when using straight cable, the connection is made from
the uplink (MDI) port of the switch to any port of the hub. Figure 8 also
demonstrates that the connection can be made from any (1X-4X) port of the
switch to any port of the hub when using crossover cable.
Switch-to-Switch Installation
The AT-FS704 switch can be connected to any switch or other device (routers
or bridges) using a two-pair Category 5 UTP/STP RJ45 straight or crossover
cable, as shown in Figure 9.
POWER
10BASE-T/100BASE-TX
4 PORT ETHERNET SWITCH
Straight Cable
Figure 9 AT-FS704 Switch to Switch Connection Using the Straight or Crossover Cable Options
Figure 9 demonstrates using straight or crossover cable. When using straight
cable, connect the uplink (MDI) port of the switch (Switch A) to any 10 Mbps or
100 Mbps (MDI-X) port of the other switch (Switch B), or other device. When
using crossover cable, connect any (MDI-X) port of the switch (Switch A) to any
10 Mbps or 100 Mbps (MDI-X) port of the other switch (Switch B), or other
device.
12
Switch A
1
2
3
4
=
1
X
100M
LINK/ACT
FULL DUP
COLN
To HUB
To PC
10BASE-T/100BASE-TX
4 PORT ETHERNET SWITCH
2X
3X
4X
Switch B
1
2
100M
LINK/ACT
FULL DUP
POWER
COLN
Crossover Cable
3
4
=
1
X
2X
3X
To HUB
To PC
4X
Tabla de contenido
