Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPERATING
1.
Place tape and applicator roller on the front corner
of the box. Center it over the seam. Tack tape lead
end to side of box. Then roll the dispenser up, over
the corner of the box. (See Figure 4)
REPLACING THE BLADE
CAUTION! Use care when working near the
sharp blade.
1.
Remove the blade screws and nuts to remove used
blade.
PAGE 2 OF 6
INSTRUCTIONS CONTINUED
Figure 4
START
HERE
2. Pull the dispenser across the top of the box, applying
pressure to the applicator roller to obtain a tight seal.
3. Continue to tape 2½ to 3" past the end of the box.
4. Brush the wipe-down plate against the box, push
down and twist slightly to cut and secure the end of
the tape to the side of the box.
2. Install the replacement blade with serrated cutting
edge pointing away from the applicator roller.
3. Replace and tighten the blade screws and nuts to
secure the blade.
1-800-295-5510
uline.com
1020 IH-730
Tabla de contenido
