Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
Hardware Installation
Power on the Device.
To power on the AP, you can use one of the following methods:
1. Plug one end of your Ethernet cable into the LAN port of the AP, and the other
end into a port on a PoE switch or a 802.3af PoE injector.
2. Connect the power
Configuring the Device
To set up and manage the AP, you can use one of the following methods:
1. Connect the access point and your computer to the same switch or router.
Manage the access point from the computer. (Figure 4)
2. Connect the access point to a Wireless Controller. Connect your computer to
the same network as that of the Wireless Controller. Manage the access
point from the computer via the Wireless Controller. (Figure 5)
Software Installation
To login to the LevelOne AP, please perform the following steps:
1. Check Your Network Settings to login web UI.
Please make sure your PC can get IP address automatically, so the router can
communicate with your PC during configuration.
l Select "Control Panel" > "Network Connections".
l Right click the "Local Area Connection" and choose "Properties".
l Select the TCP/IP protocol for your network card.
l Change the IP Address of PC: To configure the IP Address, click the network
icon to open the Ethernet dialog to configure the IP Address. Select
"Properties", choose "Internet Protocol (TCP/IP)" and select "Properties".
Input the IP Address "192.168.188.2 ~ 192.168.188.250" and continue.
(Figure 6)
2. Launch a Web browser (Microsoft Internet Explorer 8 for example), enter the
AP's default LAN IP address 192.168.188.253 in the address bar, and then
press Enter, as shown in the following picture. (Figure 7)
3. Then enter the default password of admin in the Password fields, click "Login"
to access the AP's Web GUI. (Figure 8)
adapter.
(optional)
-3-
Tabla de contenido
