Pre-Installation - DURAVIT SensoWash Starck f Instrucciones De Montaje

Ocultar thumbs Ver también para SensoWash Starck f:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 6
Rated voltage
# 612 ... .. 2 .. ....
# 612 ... .. 1 .. ....
Max. rated power
Circuit breaker
RCD
Protection degree
Protection class
Position of electrical / water connection
180
7
1/8"
IG 1/2"
90
90
3
3
1/2"
1/2"
Set the height of the toilet based on the position of the drain
according to the technical drawing of the toilet.

Pre-installation

DANGER
Risk of fatal electric shock
> Disconnect electrical components from the power supply
before the installation.
> Check that all components are de-energised.
> Prevent the power supply from being switched on
accidentally by third parties.
> Ensure that there is no damage to the power supply cable.
> Lay a permanent power supply line which must be on a
separate circuit:
> Observe the position of the electrical connection
> Leave at least 800 mm (31½ ") of feed cable exposed
> Install circuit breaker
> If the product itself does not have electrical leakage
protection function, it must be installed in circuit where
there is leakage protection device installed.
> Means for disconnection must be incorporated in the
fixed wiring in accordance with the wiring rules and
having a contact separation in all poles that provide full
disconnection under overvoltage category III conditions.
220 – 240 V 50 – 60 Hz
100 – 120 V 50 – 60 Hz
(Taiwan models)
1080 W
I
= 16 A
N
I
= 30 mA
N
IP X4
1
Cold water
Water pressure
Water hardness
Pre-installation
> Install the water connection and water outlet in the specified
areas.
Health risk and potential product
WARNING
damage!
> Supply the product with tap water from the main water
system only.
> Do not connect any waste water, grey water, industrial water,
sea water or other untreated or semi-treated water.
NOTICE
Product damage due to limescale build-up
In regions with hard water, limescale build-up can impair the
performance of the product.
> Check the water quality in your region. Duravit recommends
the installation of a water softener with water hardness
≥ 14° dH (2.5 mmol/l).
5
Connecting the water
NOTICE
Avoiding any malfunctions.
> The new hose-sets supplied with the appliance are to be
used and old hose-sets should not be reused.
DN15 (½ ")
0.07 – 0.75 MPa (10 – 109 psi)
max. 2.4 mmol/l (240 ppm)
57339_Mounting_SeWa_Starckf_WWC/20.09.2
5
Tabla de contenido
loading

Tabla de contenido