General Troubleshooting - TECshow STRATUS 400 Manual De Usuario

7. GENERAL TROUBLESHOOTING

Symptom
No output or fog machine
is spitting fluit.
Circuit breaker or fuse keeps
blowing.
Product does not power up.
Product stops pumping/Loud
noise.
If you still experience problems after trying the
solutions presented here, contact AMPRO Technical
Support.
Possible Cause
Incorrect fluid
Blocked pipe ar falling part.
Excessive load on the circuit.
Short circuit along the power
lines.
No energy on power outlet.
Loose of damaged power cord.
Blown fuse.
Internal problem.
Low/No fluid.
Pump protection system engaged. Release manual fog button, and
Design and product specifications are subject to
change without prior notice.
Possible Action
Clean thoroughly with Ampro FCQ.
For full instructions, see Fogger
Maintenance. Refill with Ampro
water-based fog fluid.
Contact Customer Service.
Make sure that the total load does
not exceed 80% of the breaker or
fuse rominal current.
Check the power lines and power
cords.
Check power outlet
Change to another outlet
Check the power cord.
Replace blown fuse with a good
one of the same type and rating.
Send product for repair.
Refill product with fluid.
press it again to reset pump pro-
tection system.
English version | Tecshow Stratus 400
P. 9