Fuse Replacement; Mounting Diagram - TECshow STRATUS 400 Manual De Usuario

4. SETUP
AC Power
To determine the product's power requirements
(circuit breaker, power outlet, and wiring), use the
current value listed on the label affixed to the prod-
uct's back panel, or refer to the product's specifi-
cations chart. The listed current rating indicates
the product's average current draw under normal
conditions.
• Always connect the product to a protected
circuit (circuit breaker or fuse). Make sure the
product has an appropriate electrical ground to
avoid the risk of electrocution or fire.
Never connect the product to a rheostat (variable
resistor) or dimmer circuit, even if the rheostat or
dimmer channel serves only as a 0 to 100% switch.

Fuse Replacement

Disconnect the product from power before replac-
ing the fuse.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into
the slot of the fuse holder.
3. Pry the fuse holder out of the housing.
4. Remove the blown fuse from the holder.
5. Replace with a fuse of the exact same type and
rating.
6. Insert the fuse holder back in place and recon-
nect power.
• A spare fuse is not included; however, the safety
cap has room for a spare.
• Always replace a blown fuse with another of the
same type and rating.
Spare fuse
holder (inside
safety cap)
P. 6
Tecshow Stratus 400 | English version
Mounting
Before mounting the product, read and follow the
safety recommendations indicated in the Safety
Notes.
Orientation
When mounting the Stratus 400, make sure ade-
quate ventilation is provided around the product.
Rigging
•
•
•
•
•
Installes fuse
(held by plastic
clip)
Safety cap

Mounting Diagram

Before deciding on a location, always make
sure there is easy access to the product for
maintenance and fluid replenishment.
Make sure that the structure or surface onto
which you are mounting the product can sup-
port the product's weight (see the Technical
Specifications).
When mounting the product overhead, always
use a safety cable. Mount the product securely
to a rigging point, such as an elevated platform
or a truss.
When rigging the product onto a truss, you
should use a mounting clamp of appropriate
weight capacity. The bracket has an M8 size
hole, which are appropriate for this purpose.
The bracket adjustment knobs allow for direc-
tional adjustment when aiming the product
to the desired angle. Only loosen or tighten
the bracket knobs manually. Using tools could
damage the knobs.