Using Irig Stomp With Guitar/Bass Amplifiers; Usage Tips - IK Multimedia iRig STOMP Guía Rápida De Inicio

Using iRig STOMP with Guitar/Bass
Amplifiers
When using iRig STOMP with guitar amplifiers:
• Use an amp that doesn't have distortion (Clean channel)
if you are making your amp tone on the AmpliTube app.
• Use an amp that can deliver both clean and overdriven
sounds if you are using the AmpliTube app mainly for
effects and stomp boxes emulation.
• It is not recommended to use an amp with an overdrive
channel if you are also using the amp emulation on the
AmpliTube app.
• You can insert the iRig STOMP in any existing pedalboard,
between any kind of effects, exactly like you would do with
any other stompbox.
Using iRig STOMP with a PA system
With iRig STOMP, you can perform onstage without
carrying heavy amplifiers. The AmpliTube app's built-in amp
modeling will deliver the right tone, and iRig STOMP allows
you to directly connect to the stage mixer or speakers. To do
this, use the iRig STOMP L and R line outputs.
Powering iRig STOMP
iRig STOMP can be powered either by a 9V battery or an
external DC supply. When the DC plug is inserted, the
internal battery is automatically disconnected to save its
charge.
iRig STOMP turns off automatically when no instrument
jack is inserted. When using external DC supply, be sure
the adapter provides 9VDC and can deliver at least 0.5A.
Also be sure your adapter has this polarity:

Usage tips

• To avoid excessive noise or risk of feedback, always be
sure that the INPUT knob on iRig STOMP is set properly.
Check the input level meter on the AmpliTube app, from
the SETUP page. When you play hard, this level meter
should peak at max occasionally. If it is too low, rotate the
INPUT knob clockwise. If it is too high, rotate the INPUT
knob counterclockwise. See below for typical INPUT gain
settings per instrument type.
Active
guitar/bass
L
iRig
• If you need to use only one iRig STOMP output channel,
always use L. This is because both channels are mixed
when using only this connection.
• If the sound on headphones or on the Line Out is distorted
or the red LED brightness has become dim, it's time to
Humbucking
passive
guitar/bass
Single Coil
passive
guitar/bass
MAX
INPUT