CLEARING THE NEEDLE
Remove Needle following steps 1-3 from
1.
previous section: "Thoroughly Cleaning the
System."
Insert Needle Clearing Brush into top of
2.
Needle and twist to release particles.
Remove Brush. Repeat as needed.
Submerge open end of Needle Clearing
3.
Tool in cup of warm, clean water. Pull
plunger to draw water into Tool.
Insert Needle into open end of Tool until
4.
fully seated.
Press plunger quickly to push water
5.
through Needle.
NOTE: Repeat until Needle is clear.
Reassemble System following steps
6.
6-9 from previous section: "Thoroughly
Cleaning the System."
2
3
4
5
16
TROUBLESHOOTING
PROBLEM
PROBABLE CAUSE
Wine is not
System is not completely
pouring.
seated onto wine bottle
(Light Ring is still BLUE).
Bottle is not tilted enough.
Battery is empty.
Coravin Capsule is empty
or missing. Light Ring
is
RED.
Needle is clogged
or damaged.
Filter in Needle is clogged.
Wine is pouring
Pour slows down before
slowly.
System is finished pouring
glass of wine.
Sip Mode may be engaged.
Sip Icon is illuminated.
Needle is clogged
or damaged.
Filter in Needle is clogged.
It is difficult
Coating on Needle may
to insert and
be worn.
remove System
from wine
Some corks are more
bottles.
difficult than others.
Wine is built up on
the Clamp.
SOLUTION
Push System completely down
further onto bottle. Light Ring will
turn
GREEN.
Raise bottom of bottle higher.
System will pour automatically
when bottle is tilted enough.
Charge System.
Install new Coravin Capsule
only when Light Ring is
RED.
Replace if damaged. If clogged,
refer to "Clearing the Needle."
Refer to "Cleaning the System."
This is normal. Wine pours more
slowly towards end of glass.
Push Button to turn Sip Mode off
and pour faster.
Replace if damaged. If clogged,
refer to "Clearing the Needle."
Refer to "Cleaning the System."
Replace Needle if tip is
worn or damaged.
This is normal. Use Handle for
extra leverage to remove System
from bottle.
Rinse clamp thoroughly under
warm, clean water. Refer to
"Cleaning the System."
17