Idiomas disponibles
Idiomas disponibles
12
36. Remove the retainer (1) from the positive battery ca
ble junction block.
37. Remove the positive battery cable (2) from the posi
tive battery cable junction block.
38. Disengage the retaining tabs securing the positive bat
tery cable junction block and reposition the junction
block.
39. Looking in from the front passenger side interior, lo
cate the positive battery cable and grommet under the
glove box area.
40. Remove the grommet from the inner dash panel and
pull the grommet and battery cable rearward.
41. Locate and remove the small connector from the kit
supplied overlay harness (3).
NOTE: The terminal ends will be the same size.
WARNING: To avoid personal injury or vehicle dam
age, use extreme caution not to slice or puncture the
positive battery cable!
42. Using a small flat bladed screwdriver or equivalent,
carefully position the tool into the opening
between the cable and the grommet .
43. Feed the overlay harness (3) through the grommet
opening, allow a generous amount to feed towards
the TIPM area.
44. Feed the overlay harness into the dash panel opening
towards the TIPM area.
45. Carefully remove the tool from the grommet.
Feb 18, 2011
K6860984
