Glem GFLP Manual De Uso página 17

3172618-006 ItIFPE 09/04/15 11:50 Página 17
PROGRAMMING AND OPERATING THE PYROLYTIC FUNCTION
Follow the instructions below to carry out a
pyrolytic cleaning cycle:
1 IMPORTANT: Remove all accessories
(shelves, grids, side supports to hold up
the shelves, telescopic guide rails) from
inside the oven.
2 Turn the cooking control dial to Pyrolysis
position .
3 Next, press the
should appear on the timer display.
4 After a few seconds, P2 (pyrolysis program-
me 2) will appear on the timer display, the
BACK symbol will also remain lit up.
5 You can now change the pyrolysis programme
to P1, P2 or P3 by pressing the + or – keys:
P1: Minimum programme. Duration 1 hour
P2: Standard programme. Duration 1 hour
and 30 minutes
P3: Maximum programme. Duration 2 hours
6 You will hear 2 consecutive beeps after
several seconds or by pressing the
key confirming the chosen programme.
7 You can still change the pyrolysis program-
me by pressing the
keys.
8 After a short time, you will see the time
remaining for the selected programme to
end and the symbols
on the timer display. The pilot light
turn on and the oven door cannot be ope-
ned, as the heating will have begun.
IMPORTANT: If you don t press the PIRO key
after turn the dial to Pyrolysis position, the
oven will start to heat and it will make the P3
pyro cycle along 2 hours.
In the display, you will see the current time and
not the P3 program. Also, It will not possible to
modify the pyro program to P1 or P2.
IMPORTANT: At this point, the oven is pro-
grammed and the pyrolytic cleaning cycle is
underway. During the cycle, none of the timer
functions can be selected, except the child
lock. Do not try to open the oven door as it may
interrupt the cleaning process.
key, the word PIRO
PIRO
PIRO
key and the + or –
PIRO
and BACK lit up
will
9 When the pyrolytic cleaning cycle has finis-
hed, an alarm will sound, the symbol
will flash and you will see the correct time
on the display.
10 Press any of the timer's keys to disable the
alarm.
11 Set the cooking control dial to position
12 The oven's heating process has ended,
however the oven is extremely hot and can-
not be used. The cooling motor will opera-
te until the oven cools down, pilot light
will remain on and the symbol
flash on the timer display.
IMPORTANT
The cooling process may last up to 2 hours
owing to the high temperatures inside the
oven.
13 Once the oven has cooled down, pilot light
will automatically turn off.
14 Press the key to stop symbol 9 flas-
PIRO
hing. .
IMPORTANT
To open the door (pilot light
dial must be in position
instruction 11 set the control dial to position
and wait a few minutes until the door unlocks
and the pilot light switches off.
15 Open the oven door and wipe the inside
with a damp cloth, cleaning up the ash
from the cleaning cycle. Areas in the oven
that are difficult to access will need to be
cleaned with a non-metallic fibre scourer.
16 Once the oven is clean, do not forget to
replace the supports and accessories.
17 The oven is now ready to be used.
IMPORTANT: If any incidents are detected in
the programming and operating of this func-
tion, consult the section "Incidents while
Operating the Pyrolytic Function".
.
will
on), the control
. If you did not follow
17