BRASS Akron MERCURYMASTER 5147 Instrucciones De Funcionamiento página 4

OPERATING INSTRUCTIONS
• To change the spray angle rotate the pattern sleeve. Rotate it clockwise for straight stream and counterclockwise for wide fog.
• The Style 5147 has an adjustable flow rate. To change the flow rate, shut off the flow then push the baffle head in and rotate
until the desired setting aligns with the roll pin. Then adjust your engine to provide 75 psi at the inlet of the nozzle.
NOTE: Changing the flow setting without adjusting the pressure will affect your actual flow rate i.e. if you change to a higher flow
setting, your inlet pressure will decrease and flow will be less than shown on the baffle head . If you change to a lower flow
setting, your inlet pressure will increase and your flow rate will be more than shown on the baffle head .
MAINTENANCE
• Under normal conditions, periodically flushing the nozzle with clean water and cleaning grit and dirt from around exterior moving
parts will allow the nozzle to operate as designed .
• Periodically (at least annually), lubricate the pattern sleeve with Low-Temp Lubripate.
• Over time the seals and turbine teeth may need replaced. this can be accomplished by purchasing the appropriate Akron repair
parts. Use qualified maintenance mechanics or return the nozzle to Akron Brass for repair.
ISO 9001 REGISTERED COMPANY
PHONE: 330.264.5678 or 800.228.1161 I FAX: 330.264.2944 or 800.531.7335 I akronbrass.com
WARRANTY AND DISCLAIMER: We warrant Akron Brass products for a period of five (5) years after purchase against defects in materials or workmanship. Akron Brass will repair or replace
product which fails to satisfy this warranty. Repair or replacement shall be at the discretion of Akron Brass. Products must be promptly returned to Akron Brass for warranty service.
We will not be responsible for: wear and tear; any improper installation, use, maintenance or storage; negligence of the owner or user; repair or modification after delivery; damage; failure to
follow our instructions or recommendations; or anything else beyond our control. WE MAKE NO WARRANTIES, EXPRESS OR IMPLIED, OTHER THAN THOSE INCLUDED IN THIS WARRANTY
STATEMENT, AND WE DISCLAIM ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE. Further, we will not be responsible for any consequential,
incidental or indirect damages (including, but not limited to, any loss of profits) from any cause whatsoever. No person has authority to change this warranty.
© Akron Brass Company. 2011 All rights reserved. No portion of this can be reproduced without the express written consent of Akron Brass Company.
revised: 8/11