Genebre 3912 00 Guia Del Usuario página 5

INSTALLATION
Place this device far from any heat source or air flow, at about
a 1,5 m. height from the floor.
Open the device pushing the clip on the base bottom side
(Fig.1 A). Rotate the front cover upward (Fig.1 B) and lift
slightly to unfasten it. (Fig. 1 C). Remove the inner protection
cover for the electrical connections unscrewing (Fig.2 C) then
rotating upward to release it. Fix the base onto the wall, using
the horizontal (Fig.2 A-A) or diagonal holes (Fig.2 B-B).
Dispose the cables through the window on the bottom and
connect the wires to the terminal block (Fig. 4) then put the
inner protective cover back and fix the screw again (Fig.2 C).
insert the batteries in their compartment on the display board
(Fig. 3). Close the device proceeding like before reversing the
operation order: match the upper side of the two parts (Fig.1 C)
then rotate the front cover downward (Fig.1 B) until the clip on
the base clacks (Fig1 A).
BATTERÍES REPLACEMENT
When the symbol of empty batteries flashes on the display
(out of power batteries)
front cover back to the base before performing any operation
on the control.
DESCRIPTION OF COMMANDS AND OPERATIONS
Command keys are accomplished on a four position ring each one identified by the arrows ◄►▲▼and an
additional key in the middle, hereafter named OK.
Press the ring exactly on the arrows to avoid multiple keys activations. Press OK key in the middle.
Use arrow keys to modify time and temperature values or select the available options. OK key is usually to
confirm settings.
FIRST START (Fig. 5)
Setting the clock
Set 12H or 24H hours format by ▲▼, then OK.

Set hours by ▲▼, then OK.

Ser minutes by ▲▼, then OK.

The display shows OFF and the clock.
OFF MODE (Fig. 6)
Anti-Frost function is active
Hold the following keys for 3 seconds to:
▼ set the clock (see "Setting the clock")

▲ set the season mode (Summer / Winter)

 ◄ switch back and forth between active modes and OFF
Hold OK for 10 seconds to enter the installation Menu
ACTIVE MODE (Fig. 7)
Ambient temperature is always in the foreground.
Press OK to show the clock or the set-point temperature in the
upper ring corner.
Press ► to select Comfort o Economy (ECO) temperatures.
Press▲▼ to change and save the temperature set-points.
SEASON MODE WINTER 
Comfort temperature is greeting than Economy (t1>t2).
When Tamb < Tset heating turns on heating.

SEASON MODE SUMMER 
Comfort is smaller than Economy (t1<t2)
When Tamb > Tset cooling turns on refrigeration
(Fig.1 , Fig.3 ). Re-assemble the
.
R0 Pág.
5