Tabla de contenido
Fax +32 2 359 95 50
Limpeza do filtro HEPA
O filtro HEPA
and the cover should be cleaned regularly. Cleaning is best done when emptying
o contentor do pó.
1.
Switch off
always pull on the plug and not on the
2.
Now lift out
3.
Turn the dust container cover carefully (J) until it is released and
away easily
4.
Now rinse
Atenção!
Only ever clean
These would destroy
5.
Place
o filtro HEPA
contentor do pó. Coloque o contentor do pó dentro do aparelho, encaixando-o no
lugar.
Your cyclone vacuum cleaner is now ready for use again.
Motor protection valve
The unit has the protection valve, when the dust cup is full of dust,
the air path is blocked, the protection valve will turn on automatically avoiding motor over-
heat in order to prolong the life of motor.
Limpeza
of the other parts
The casing, dust collecting chamber and filter chambers
damp cloth if required. No liquid must enter the
cleaning substance (scouring liquids, thinners), since these will corrode the plastic surface. Only
place the plug back in the mains socket when you have made sure that all the parts are
thoroughly dry.
Hair and fluff may gather on the running wheels and on the floor nozzle
You should remove these to ensure that handling
Note! Lubricating or oiling of the roller bearing is not recommended, because this will cause dirt
and fluff to stick even better.
CONSELHOS PRÁTICOS
•
Quando limpe escadas, aconselhamo-lo a manter a unidade na posição vertical.
•
As aberturas na traseira do aparelho permitem encaixar os tubos das escovas assim que
o aparelho está em funcionamento, por exemplo quando na deslocação de móveis ou
quando se desliga o aparelho para o guardar.
•
O aspirador não necessita de manutenção regular, á parte das tarefas para limpar o filtro
que descrevemos anteriormente.
PROBLEMAS E SOLUÇÕES
Faults can occur on all electrical equipment. This must not necessarily be due to a defect in
the device itself. So check first with table if the fault can be dealt with.
PROBLEMA
Weak suction
Copies of the I/B. Please reproduce them without any
changes
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
To do this follow the instructions in the
o aspirador e retire o cabo da alimentação da tomada eléctrica.
o contentor do pó.
(K).
o filtro HEPA
under running water and allow it to dry
o filtro
with clean water and do not use soap or detergent.
o filtro.
back in the cover (or replace with a new one) and fit it into
do aspirador
CAUSA POSSÍVEL
The secondary valve is
open
An object is blocking the
suction pipe
Filters are not fitted
properly or are blocked
Assembly page 38/67
except
under
special
"Esvaziar o contentor de pó"
cable.
o filtro HEPA
do aspirador
aspirador
in the process. Never use strong
do aspirador
is always easy.
SOLUÇÕES / CONSELHOS
Close the secondary valve
Check the suction tube, the
handle area, suction pipe and
the nozzle in use for blockages
Fit a new filter
38
instruction
from
Team
section.
To do this
o filtro HEPA
will come
(L).
o
is blocked or
can be wiped with a
do aspirador
in time.
TKG VC 1022 - 170214
Tabla de contenido
Solución de problemas
