Steelcase Tethering Worksurfaces to Answer Beam Instrucciones De Montaje página 3

®
3.
Prepare and install any additional worksurface
support means. (See Assembly Directions 939500594
for Post Legs and 100140 for Loop Legs)
4.
Set the worksurface onto the tether brackets (4a),
securing each bracket with four (4) 1" long truss head
screws (4b).
NOTE: Worksurfaces can be adjusted
laterally, while tethered to the top cap
(for 1/2" gap applications) by angling
their fronts up enough to allow the
tether brackets to slide. DO NOT slide
worksurfaces with storage units
attached.
5.
If storage units are the additional
means of support, adjust the storage
unit glides to close the gap between
the worksurface and the storage unit,
and to level the storage unit and the
worksurface.
6.
Once the worksurface and storage
unit are properly aligned, secure the
storage to the underside of the
worksurface using fasteners included
with the storage unit.
4a
FLUSH
6
4b
Page 3 of 12
100139 Rev B