jcm-tech MINIMAN+DCS Manual De Instrucciones página 14

When any loss of voltage is detected or the "low
battery" prompt appears on the display of the
programmer, the supply battery must be replaced
in the rear of the device.
The use of alkaline batteries is recommended.
4.1 STARTING
Set the supply switch to "ON". The display shows a message with the unit name and the
program version number and a short beep will be heard.
Then the portable programmer will ask you for the 6-figure password. Each time you
press a figure of the password, the display will show the symbol "*" and a short beep will
be heard. When entered correctly, the password must be
validated pressing the key
may be deleted before validation by pressing the key
If a wrong password is entered, the display will show the
message:
Once the correct password has been entered, you enter the screen "Main Function Menu".
Both the main menu and the other sub-menus are direct access, which means that it is
only necessary to press the corresponding key to enter the menus.
When you are in any function and wish to return to the display
"(Choose function)", just press the key
4.2 ADD INSTALLER CODE FUNCTION
Press the key yand the following screen appears:
Then insert the transmitter in the connector and press any
channel button. A short beep and the momentary appearance of the confirmation screen
will indicate that the operation has been carried out correctly.
Once finished, you will return to the previous screen. This
operation may be repeated as many times as necessary.
3. MAINTENANCE
4. WORKING
. If the password is wrong, it
.
14
.