Mellerware MAESTRO Manual De Instrucciones página 5

3.3. Blender jug
3.3.1. Put the bowl on the power unit first, Then turn
the bowl in clock-wise direction, until hearing the chat-
tering sound; Put the cover on the bowl, and turn it until
hearing the chattering sound.
3.3.2. Place the ingredients into the Blender jug and fix
the Blender jug cover onto the body tightly
3.3.3. Put Blender jug on the power unit till cup support
connect with power unit properly.
3.3.4. Connect the power plug of the machine and
switch on the food processor. Turn the knob to the
required level. The speed is increased by levels. PULSE
is the highest level . Turn the knob to the PULSE for any
intermittent operation.
3.3.5. You can add some liquid (such as oil, cream,
juice) to the food by removing the Blender Jug Cup. Do
not do this while blending. Stop the machine first.
3.3.6. Turn the knob to "0" level and shut off the
machine after working. Pour the mixed food out of the
Blender jug.
26210_IM.indd 5
3.4 Once you have finished using the appliance:
3.4.1. Allow appliance to cool down.
3.4.2. Unplug the appliance from the mains power
supply.
3.4.3. Clean the appliance as described in the cleaning
section.
3.4.4. When the blender is in the state of idle operation
(e.g. there is no food in the glass jug), the appliance
should not be used for more than 10 seconds.
4. Cleaning
4.1. Disconnect the appliance from the mains power
supply and allow it to cool completely before undertak-
ing any cleaning task.
4.2. Clean the glass jug, lid, blade base and blades
with sealing ring with hot water. Dry well before reus-
ing. CAUTION! The blades are very sharp. Care must
be taken while cleaning the appliance.
4.3. Clean the outer parts of the appliance with a damp
cloth with a few drops of washing-up liquid and then
dry. CAUTION! Do not immerse electrical parts of the
appliance in any liquid.
4.4. Do not use solvents, or products with an acid
or base pH such as bleach, or abrasive products, for
cleaning the appliance.
4.5. Never submerge the appliance in water or any
other liquid or place it under running water.
4.6. The blades cannot be sharpened. Replace them if
they are not cutting properly or are worn
5. Anomalies and repair
5.1. Take the appliance to an authorised support centre
if product is damaged or other problems arise.
5.2. If the connection to the mains has been damaged,
it must be replaced and you should proceed as you
would in the case of damage.
.
2019-10-07 01:48:12 PM