Mellerware PURIFY Manual De Instrucciones página 3

3.2.3. Fitting the new filter:
Step 1: Remove the filter from its packing and check if
it's in good condition.
Step 2: Detach and remove the top cover from the puri-
fier. Insert the new filter element in the base by gently
pushing it down.
Step 3: Before placing the top cover and tightening the
cover to the base; make sure that the waterproof ring is
in position in the groove
3.2.4. Installation procedures for 3 different tap taps:
1. Threadless tap
- Loosen the tap attachment with a slotted screwdriver.
Insert the attachment to the mouth of the tap and
tighten. Ensure there is no leakage.
- Ensure the rubber seal between the tap attachment
and the connecting ring of the water purifier is intact.
Note: leakage will occur if this seal is missing
- Connect the water purifier to the tap attachment and
tighten.
- Turn on the water purifier and switch the lever back
and forth to test the leakage. If there's no leakage, let
water flow continuously until water becomes clear.
PLEASE REFER TO THE PICTURE BELOW:
2. Internal threaded tap
- Replace the existing tap attachment with the one that
has either a 22mm or 24mm external thread
- Insert a rubber between the tap attachment and the
tap. Connect the tap attachment to the tap and tighten
- Ensure the rubber seal between the tap attachment
and the connecting ring of the water purifier in intact.
Note: leakage will occur if this seal is missing.
- Connect the water purifier to the tap attachment and
tighten.
- Turn on the water purifier and switch the lever back
and forth to test for leakage. If there's no leakage, let
water flow continuously until water becomes clear.
PLEASE REFER TO THE PICTURE BELOW:
3. External Threaded tap
- Replace the existing tap attachment with one that has
22mm internal thread.
- Insert a rubber seal between the tap attachment and
the tap. Connect the tap attachment and the tap and
tighten.
- Ensure the rubber seal between the tap attachment
and the connecting ring of the water purifier is intact.
Note: leakage will occur if this seal is missing.
- Connect the water purifier to the tap attachment and
tighten. Turn on the water purifier and switch lever back
and forth to test for leakage. If there's no leakage, let
water flow continuously until water becomes clear.
- NOTE: The connecting ring of the water purifier has