Section 5 − Installation; Required Torch Parts And Torch Assembly; International Style Connector Assembly - WeldCraft WP-17-12-R Manual Del Operador

3-1. Required Torch Parts And Torch Assembly

15
1
1 Cup
2 Collet Body
3 Collet
4 Heat Shield
5 Backcap Insulator
6 O-Ring
7 Backcap
8 Torch Body/Torch Head

3-2. International Style Connector Assembly

1
2
Tools Needed:
OM-225 427 Page 4
SECTION 3 − INSTALLATION
4
3
2
Assembling Torch Parts
!
Before welding, insure that the torch
head is firmly attached to the torch
body.
9 Handle
10 One-Piece Power Cable
11 Power Cable Adapter
12 International Style Flow-Through
Adapter
Note: Adapter needed only if torch is
equipped with one-piece cable.
13 Two-Piece Power Cable
7
5
6
9
8
Or
13
3
1 in
(26 mm)
5
4
3
10
14
14 International Style Connector
Note: Connector needed only if torch is
equipped with two-piece cable (see Section
3-2).
Assembling Torch Body
Keep connections tight. Replace cup, heat
shield, and backcap as needed.
15 Tungsten Electrode (See Section 5)
Installing Tungsten
To adjust tungsten position,
backcap.
1 Weld Output Cable
2 Insulating Boot
3 Sleeve
Slide insulating boot onto cable;
strip cable and install sleeve.
4 Connector Body
5 Setscrew
Insert cable with sleeve fully into
connector body, tighten setscrew,
and slide insulating boot over con-
nector.
11
12
804 305-A
loosen
ST-156 496