GiBiDi SR100 Instrucciones De Instalación página 13

SR100
FUNCTIONS SETTING ( DIP SWITCH DIP2)
Settings are memorized when the door is closed.
DIP Status Function
ON
DIP1
PHOTOCELL
OFF
ON
DIP 2
STOP NC
OFF
DEFAULT SETTINGS
DIP1 ON
DIP2 ON
SIGNALLING LEDS
Led Colour
DL1 Green GENERAL OPEN
DL2 Green GENERAL CLOSE
DL3 Green
DL4 Green
DL5 Yellow
DL6 Red
DL7 Red
ON BOARD RADIO MANAGEMENT
SPECIFICATIONS
Radio receiver 433,92 MHz
Memorizable codes max 200
CODES LEARNING
Press the LEARN key, the DL8 led switches on (it remains on for 6 s, then it switches off).
Press the key selected with the dip n° 6 – 7 of the transmitter that has to be set, and the receiver gives a start
command to the control unit. Without pressing again the LEARN key, it is possible to memorize other transmitters of
the same kind one after the other until the DL8 led remains on. After the learning of the last transmitter, wait until the
led switches off (about 6 s) to indicate that the system has left the learning procedure and is now ready for the
standard work.
Without pressing the LEARN key, it is possible to memorize the transmitters just by pressing simultaneously the keys
1 and 2 of a transmitter already memorized on the control unit for about 6 s. In this way, the transmitter enters the code
learning mode; it is now necessary only to press any of the keys of the new transmitter that has to be memorized.
MEMORY DELETION
In case of mistake, or when the complete deletion of all codes is necessary, press the LEARN key (the red led
switches on) and keep it pressed until the led switches off.
Description
Disables PHOTO input
PHOTO input enabled
Disables SAF input set as STOP with NC contact
Enables SAF input set as STOP with NC contact.
Enables 8K2 edge reading
Signal
Description
It switches on when the contact is closed
It switches on when the contact is closed
START
It switches on when the contact is closed
MEMO
See "Times learning procedure"
The led switches on with the SAF input enabled. It remains on for 2 s, then it
SAFETY
switches off and, after a few seconds, on again.
PHOTOCELL
It switches off when the photocell contact opens
RADIO
See "On board radio management"
13
UK