Changing The Input Source - SOUNDMASTER UR620 Manual Del Usuario

UR620 / English Instruction Manual
BACKUP BATTERY INSTALLATION
Open the battery door (21) by pushing in on the tabs, then removing the door.
Insert two (2) 'AAA' batteries following the correct polarity indicated in the battery compartment.
Replace the battery door (21) back on the compartment.
NOTES: The batteries are used to back-up the clock and alarm times when the AC adaptor is
disconnected or there is a power failure.
Alkaline batteries are recommended for the longest backup time.
When replacing the battery, do not disconnect the AC power adapter otherwise the current time,
alarm, and station presets will be erased.
When to replace the battery: The red LED of battery indicator will light up when there are no
batteries or when the batteries are low.

CHANGING THE INPUT SOURCE

With the UR620 powered "ON", repeatedly press the "SOURCE" button to change the input
source to cycle between FM Radio, Bluetooth or AUX IN.
PLAYING THE RADIO
With the clock radio plugged in and powered 'ON', press the "SOURCE" button, then select
FM and the frequency indicator will appear on the display.
Repeatedly press the "TUNE UP / MIN" or "TUNE DOWN / HOUR" button to manually adjust the
tuning on the display until the desired station appears.
For auto tuning, press and hold the "TUNE UP / MIN" or "TUNE DOWN / HOUR" button until the
display starts to scan then release the button and the tuner will search and stop on the next
strong station. Repeat this process until the desired station appears on the display.
NOTE: Fully extend the FM wire antenna to increase reception sensitivity. Keep digital music
players or mobile phones away from the FM antenna as this may cause interference. Do not
place the FM antenna near the AC power adaptor as this may lead to reception interference.
SETTING RADIO PRESETS
To store a radio station to memory, first follow the steps above to tune in the desired station.
Press and hold the "PLAY/RADIO PRESET" button to create a preset for the current station.
"P" will appear and "##" (the preset number) will blink on the display.
Press the "TUNE UP / MIN" or "TUNE DOWN / HOUR" button to select a preset number (01- 10).
Press the "PLAY/RADIO PRESET" button again to confirm the setting and the station will be
saved into memory. Repeat these steps for up to 10 presets, as desired.
To recall a preset station, repeatedly press the "PLAY/RADIO PRESET" button until the desired
preset number appears in the display and the station tunes in.
2