Petzl SEQUOIA SRT Manual Del Usuario página 4

6
Preparation, adjusting the harness
You can adjust the height of the "attachment bridge"
according to your specifi c needs (usage, techniques,
body morphology.
- 3 positions possible). This adjustment allows a good
distribution of pressure over the leg loops and waist
belt.
6
Preparation,
adjusting the harness
- Close and use a drop of thread-lock on the
screw (obligatory).
- Tighten the screw until the red indicator is no
longer visible; continue tightening to a torque
of 3 Nm.
Verify that the 3 straps are correctly positioned
in the gated rings (straps should not be twisted
or intertwined).
Do not use the SEQUOIA without the ATTACHMENT
BRIDGE.
Adjustment and suspension test
Your harness must be adjusted to fi t snugly to
reduce the risk of injury in case of a fall.
You must move around and hang in the harness
(suspension test) from each attachment point
with your equipment to verify that the harness
fi ts properly, provides adequate comfort for the
intended use and that it is optimally adjusted.
4 C69AF0 SEQUOÏA SRT C695010C (280708)
- Open the GATED RINGS by unscrewing the spacer with a
n° 25 male Torx driver.
- Reposition the straps.
7
BELT FOR RESTRAINT
AND WORK POSITIONING EN 358
Attachment points 7A. «D» lateral
meeting the EN 358
attachment points.
standard:
The two "D" lateral
These attachment
attachment points must
points are designed
ALWAYS be used together.
to hold the user in
position at his work
station (work in
suspension: work
positioning). These
attachment points
must only be used to
attach to a restraint
or work positioning
system, maximum
fall height: 0.5 m.
These attachment
points are not
designed for fall
arrest use and it
may be necessary
to supplement
work positioning or
restraint systems
with collective fall
arrest systems
(e.g. safety nets) or
personal fall arrest
systems (e.g. an
EN 363 fall arrest
system).
EN 358
2000
EN 358
2000